Manx SA7x Guia de Instalação descarregar pdf (Página 21)

4. Swing the top of the door away from the cabinet, lift the bottom of the door up and out

of the bottom hinge, and set the door aside.

To install the new door:

1. Unpack the new door.

2. Set the packaging aside.

3. Ensure the top front door key pin is in the upper position.

4. Align the new front door with the bottom cabinet hinge.

5. Swing the new door into position and release the top front door key pin, locking the door

into position.

6. Attach the ground strap to the cabinet frame using the screw previously removed.

7. Close and lock the door with the hex key, if desired.

To prepare the cabinet for SA7x installation, open the cabinet front door, using a 5/32 hex

key. Use the procedures in the following sections.

3.6 Installing the Spring Clips

Nine BeCu spring clips, part number 12-20580-08, and two BeCu spring clips, part number

74-39405-01, must be installed.

3.6.1 Installing the 12-20580-08 BeCu Spring Clips

To install the 12-20580-80 BeCu spring clips into the VAX 6000 cabinet:

1. Locate the nine spring clips in the SA7x cab kit.

2. From the front of the VAX 6000 cabinet, locate the bottom front rail that has holes along

it.

Note

Some VAX 6000 cabinets may have a braided FCC gasket installed on this rail.

Remove this braided gasket and replace it with the supplied BeCu spring clips.

3. Remove gasket material, if necessary.

4. Locate the approximate center of the front rail.

5. Remove the adhesive backing strip from the spring clip to be installed.

6. Install the ﬁrst spring clip so the middle of the clip aligns with the center of the front rail

of the cabinet.

7. Install the remaining eight spring clips on both sides of the middle spring clip (four spring

clips on each side).

Installing the SA70–CK Kit 3–7

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 51 52

Sem comentários

Manx SA7x Guia de Instalação Página 21